Struts Lower Control Arm Sway Bar Link for 03-07 Honda Accord Acura 2.4L Front

Description

Fitment: HONDA ACCORD 2003-2007 2.4L Models ONLY Position: Left, Right, Front Package Included: 1x Front Quick Install Ready Strut Assembly (Driver) - 172123L 1x Front Quick Install Ready Strut Assembly (Passenger) - 172123R 1x Front Lower Control Arm - K640290 1x Front Lower Control Arm - K640289 1x Front Stabilizer / Sway Bar End Link (Driver) - K90660 1x Front Stabilizer / Sway Bar End Link (Passenger) - K90661 Description: Struts Lower Control Arm Sway Bar Link for 03-07 Honda Accord Acura 2.4L Front Fitment: HONDA ACCORD 2003-2007 2.4L Models ONLY Position: Left, Right, Front Package Included: 1x Front Quick Install Ready Strut Assembly (Driver) - 172123L 1x Front Quick Install Ready Strut Assembly (Passenger) - 172123R 1x Front Lower Control Arm - K640290 1x Front Lower Control Arm - K640289 1x Front Stabilizer / Sway Bar End Link (Driver) - K90660 1x Front Stabilizer / Sway Bar End Link (Passenger) - K90661 Description: Direct-fit design for easy installation, no special tools required Vehicle-specific tuning for perfect compatibility All-in-one unit integrating strut, coil spring (if applicable) and other full-set components Gloss black powder coating plus neoprene dust boot for excellent protection Nitrogen-charged for stable and reliable performance One-piece removal and replacement for one-step repair, boosting vehicle handling, safety and dynamic performance How to replace the Strut Assembly : Preparation： Park the vehicle on level ground and place wheel chocks. Disconnect the negative battery terminal. Loosen the lug nuts before lifting. Raise the vehicle with a jack and secure it on jack stands, then remove the wheel. Remove Old Assembly： Loosen the strut tower nuts (leave one to prevent falling). Disconnect the stabilizer links, wiring harness, and other attached parts. Remove the lower strut bolts and separate the strut from the steering knuckle. Support the old assembly, remove the last tower nut, and take it out. Install New Assembly： Inspect the new assembly for damage; do not disassemble or clamp the piston rod. Align it with the tower and knuckle, then hand-tighten one tower nut to position it. Refit the lower bolts and attached parts, hand-tightening them temporarily. Tighten Fasteners： Follow the torque specs in the service manual to tighten the lower bolts, attached parts, and tower nuts in sequence. Do not overtighten. Final Steps： Refit the wheel and tighten the lug nuts in a star pattern; retighten after lowering the vehicle. Reconnect the battery terminal and bounce the vehicle to settle the suspension. Perform a four-wheel alignment and test-drive to check for noises or pulling. Item Specifics Brand hilamps Manufacturer Part Number 13515010 Manufacturer Warranty 1 Year Placement on Vehicle Left, Right, Front Fitment Type Direct Replacement Gas Charged Shock Yes Express Split shipment Modified Item No Adjustable No Interchange Part Number 172123L,172123R Greasable or Sealed Sealed Other Part Number K640290,K640289,K90660,K90661 Payment 1.We accept any payment which can be accepted by eBay. 2.Please do check the shipping address. If you want to change the shipping address, please contact us by eBay messages. 3.If you want cancel orders or change address pls contact us within 6 hours after payment,or we are not responsible for shipping a replacement. 4.Payment must be received within 10 days as auction ended or order might be delayed. Shipping 1. Orders processed within 24 hours of payment verification. (if you want cancel orders or change address pls contact us within 6 hours after payment,or we are not responsible for shipping a replacement.) 2. The images shown are not the actual item and are for your reference only. 3. Fast shipping: All our packages use USPS First Class/UPS/Fedex... Package Service 4. If you have not received your shipment within 15 days from payment , please contact us. We will track the shipment and get back to you as soon as possible with a reply. Our goal is customer satisfaction! Returns 1. You have 30 days to contact us and 10 days to return it from the date it was received. If this item is in your possession more than 7 days, it is considered used and we will not issue you a refund or replacement. There are NO EXCEPTIONS! 2. All returned items must be in the original packaging and you must provide us with the shipping tracking number, specific reason for the return, and item custom lable. 3. We will refund your full winning bid amount, upon receipt of the item in its original condition and packaging with all components and accessories included, AFTER both Buyer and Seller cancel the transaction from eBay. OR, you may choose to have a replacement. 4. Return shipping is to be paid by the Buyer. Feedback 1. We maintain high standards of excellence (five stars review)and strive for 100% customer satisfaction! FEEDBACK IS VERY IMPORTANT TO US. We request that you contact us immediately BEFORE you give us neutral or negative feedback, so that we can satisfactorily address your concerns. 2. It is impossible to address issues if we do not know about them! Shop Category Store Home Towing Mirrors Sensors Cooling System ◈ Radiator ◈ Cooling Fan ◈ Thermostat Housing ◈ Water Pump Air Conditioning System ◈ Condenser ◈ Module & Resistor ◈ Blower Lamps ◈ Brake light ◈ Instrument Light ◈ Headlight Assembly ◈ Side Marker light ◈ Headlight Truck Bed Accessories CV Axle Shaft Alternator Coolant Overflow Tank Brake pads Steering Shaft Windshield Wiper Motor Strut Assemblies Door Handle Wheel Hub Bearing Assembly Wheel Adapters Window Switch Bumpers Window Regulator Compressor Window Visor Drive shaft CDI BOX Brake Caliper Strut & Suspension Assemblies Other Hot Item 10X White T5 74 73 Bulb Led Gauge Dash Instrument Panel Light 5630 SMD 17 18 70 USD 9.41 For 2014-2018 Chevy Silverado & GMC Sierra 1500 2500 LED 3rd Brake Light Smoke USD 31.84 LED 3RD Third Brake Light Cargo Lamp Smoke For 07-13 Chevy Silverado GMC Sierra USD 27.71 For 95-99 Chevy C1500 K1500 GMC Suburban C1500 Heater AC Blower Motor Resistor USD 13.80 Led Third 3rd Brake Light For 1999-16 Ford F250 F350 Super Duty Cargo 3D US Ship USD 22.17 Delivery New List Item Struts Control Arm Tie Rod End Link for 03-07 Honda Accord Acura 2.4L 8Pc Front USD 195.14 For Chevy Impala 3.4L 3.8L 2000-2005 Front CV Axle Brake Pads & Discs Rotors USD 197.50 Fits 2014-2018 Mazda 3/ Mazda 3 Sport 5 Lug 1Pc Wheel Hub Bearing Assembly Front USD 40.74 6pc Front Complete Struts Sway Bar Link Tie Rod Kit Fits Ford F-150 Mark LT 2WD USD 202.57 1Pc Wheel Hub Bearing Front RWD Fits Hyundai Genesis 2009-2014 Equus 2011-2016 USD 51.73 Help & Info Payment Policy Shipping Policy Return Policy FAQ About Us Struts Lower Control Arm Sway Bar Link for 03-07 Honda Accord Acura 2.4L Front Fitment: HONDA ACCORD 2003-2007 2.4L Models ONLY Position: Left, Right, Front Package Included: 1x Front Quick Install Ready Strut Assembly (Driver) - 172123L 1x Front Quick Install Ready Strut Assembly (Passenger) - 172123R 1x Front Lower Control Arm - K640290 1x Front Lower Control Arm - K640289 1x Front Stabilizer / Sway Bar End Link (Driver) - K90660 1x Front Stabilizer / Sway Bar End Link (Passenger) - K90661 Description: Direct-fit design for easy installation, no special tools required Vehicle-specific tuning for perfect compatibility All-in-one unit integrating strut, coil spring (if applicable) and other full-set components Gloss black powder coating plus neoprene dust boot for excellent protection Nitrogen-charged for stable and reliable performance One-piece removal and replacement for one-step repair, boosting vehicle handling, safety and dynamic performance How to replace the Strut Assembly : Preparation： Park the vehicle on level ground and place wheel chocks. Disconnect the negative battery terminal. Loosen the lug nuts before lifting. Raise the vehicle with a jack and secure it on jack stands, then remove the wheel. Remove Old Assembly： Loosen the strut tower nuts (leave one to prevent falling). Disconnect the stabilizer links, wiring harness, and other attached parts. Remove the lower strut bolts and separate the strut from the steering knuckle. Support the old assembly, remove the last tower nut, and take it out. Install New Assembly： Inspect the new assembly for damage; do not disassemble or clamp the piston rod. Align it with the tower and knuckle, then hand-tighten one tower nut to position it. Refit the lower bolts and attached parts, hand-tightening them temporarily. Tighten Fasteners： Follow the torque specs in the service manual to tighten the lower bolts, attached parts, and tower nuts in sequence. Do not overtighten. Final Steps： Refit the wheel and tighten the lug nuts in a star pattern; retighten after lowering the vehicle. Reconnect the battery terminal and bounce the vehicle to settle the suspension. Perform a four-wheel alignment and test-drive to check for noises or pulling. Payment Shipping Returns Feedback 1.We accept any payment which can be accepted by eBay. 2.Please do check the shipping address. If you want to change the shipping address, please contact us by eBay messages. 3.If you want cancel orders or change address pls contact us within 6 hours after payment,or we are not responsible for shipping a replacement. 4.Payment must be received within 10 days as auction ended or order might be delayed. 1. Orders processed within 24 hours of payment verification. (if you want cancel orders or change address pls contact us within 6 hours after payment,or we are not responsible for shipping a replacement.) 2. The images shown are not the actual item and are for your reference only. 3. Fast shipping: All our packages use USPS First Class/UPS/Fedex... Package Service 4. If you have not received your shipment within 15 days from payment , please contact us. We will track the shipment and get back to you as soon as possible with a reply. Our goal is customer satisfaction! 1. You have 30 days to contact us and 10 days to return it from the date it was received. If this item is in your possession more than 7 days, it is considered used and we will not issue you a refund or replacement. There are NO EXCEPTIONS! 2. All returned items must be in the original packaging and you must provide us with the shipping tracking number, specific reason for the return, and item custom lable. 3. We will refund your full winning bid amount, upon receipt of the item in its original condition and packaging with all components and accessories included, AFTER both Buyer and Seller cancel the transaction from eBay. OR, you may choose to have a replacement. 4. Return shipping is to be paid by the Buyer. 1. We maintain high standards of excellence (five stars review)and strive for 100% customer satisfaction! FEEDBACK IS VERY IMPORTANT TO US. We request that you contact us immediately BEFORE you give us neutral or negative feedback, so that we can satisfactorily address your concerns. 2. It is impossible to address issues if we do not know about them! hilamps_All rights reserved.